How to use the Swift Soak | Manicure Removal System
PREP
- Protect your station with a towel or mat to protect surface from acetone.
- Start by filing off the top coat of your manicure and trimming down any false nail tips you wish to remove.
- Gently pour hot water (<130F, DO NOT USE BOILING WATER) into base bowl to fill line.
- Place silicone bowl on top of base bowl and press down sides to snap into place.
- Pour acetone into bowl until silicone scrubbers are submerged.
- Secure lid into place and let acetone heat up from water for 5 minutes before scrubbing.
- Gently rub the surface of nails on the silicone scrubbers to remove nail enhancements. Removal times may vary depending on your manicure.
*CAUTION: The silicone scrubbers are meant to be gently scrubbed to remove your manicure. If you dig or scrape your nails into the silicone scrubbers you can damage the scrubbers which will make the Swift Soak less effective!
CLEAN
- When finished, carefully separate pieces and safely dispose of any acetone (it is not recommended to pour acetone down drain).
- Recommended acetone disposal: Soak up any extra acetone with a paper towel and throw in the trash.
- To keep your Swift Soak clean, wash the silicone with dish soap and warm water after each use.
- We recommend cleaning your Swift Soak immediately after use. Allowing the acetone or dip/gel/polish remnants to dry in the bowl will make it more difficult to clean. If this happens, add some acetone and let the remnants soften then clean as above.